Atmospheric and anthropogenic deterioration of the İvriz rock monument: Ereğli-Konya,Central Anatolia,Turkey

Bulletin of Engineering Geology and the Environment - The aim of this study is to determine the extent of deterioration of the limestone on which the İvriz rock monument is engraved. This...     

Heat propagation in thermally conductive polymers of PA6 and hexagonal boron nitride

Thermally conductive polymers offer new possibilities for the heat dissipation in electric and electronic components, for example, by a three‐dimensional shaping of the heat sinks. To face safety regulations, improved fire performance of those components is required. In contrast to unfilled polymers, those materials exhibit an entirely different thermal behavior. To investigate the flammability, a phosphorus flame retardant was incorporated into thermally conductive composites of polyamide 6 and hexagonal boron nitride. The flame retardant decreased the thermal conductivity only slightly. However, the burning behavior changed significantly, due to a different heat propagation, which was investigated using a thermographic camera. An optimum content of hexagonal boron nitride for a sufficient thermal conductivity and fire performance was found between 20 and 30 vol%. The improvement of the fire performance was due to a faster heat release out of the pyrolysis zone and an earlier decomposition of the flame retardant. For higher contents of hexagonal boron nitride, the heat was spread faster within the part, promoting an earlier ignition and increasing the decomposition rate of the flame retardant.     

Highly transparent Yb:Y2O3 ceramics obtained by solid-state reaction and combined sintering procedures

(Y_0.87-xLa_0.1Zr_0.03Yb_x)₂O₃ (x?=?0.02, 0.04, 0.05) transparent ceramics were obtained by solid-state reaction and combined sintering procedures with La₂O₃ and ZrO₂ as sintering additives. A method based on two-step intermediate sintering in air followed by vacuum sintering was applied in order to control the densification and grain growth of the samples during the final sintering process. The results indicate that La₂O₃ and ZrO₂ co-additives can improve the microstructure and optical properties of Yb:Y₂O₃ ceramics at relatively low sintering temperature. On the other hand, the addition of Zr⁴⁺ ions leads to the formation of dispersed scattering volumes in the ceramic bodies. Transmittance of 78.8% was measured for the 2.0?at% Yb:Y₂O₃ ceramic sample at the wavelength of 1100?nm. The spectroscopic properties of Yb:Y₂O₃ ceramics were investigated at room temperature. The obtained results show that the absorption cross-section at 978?nm is in the range of 2.08?×?10^–20 to 2.36?×?10^–20 cm², whereas the emission cross-section at 1032?nm is ~1.0?×?10^–20 cm².     

Cold crucible melting and characterization of titanate-zirconate pyrochlore as a potential rare earth/actinide waste form

La-Ce-Gd titanate-zirconate pyrochlore-based ceramics was synthesized at the lab-scale inductive melting unit with a 56?mm inner diameter cold crucible. Batch feeding rate and melting ratio were 3?kg/h and 3?kW?h/kg respectively. The ceramics is composed of 85–90?vol% zoned grains of the pyrochlore structure phase, the sample has excellent chemical durability in hot water and may be considered as a promising matrix for actinide – rare earth fraction of high level waste.     

Antioxidant and antimicrobial potential of cajazeira leaves (Spondias mombin) extracts

Cajazeira leaves (Spondias mombin) have their highlighted use as antioxidant and natural antimicrobial, which justifies the objective of this work to evaluate the biological activities of different extracts. In order to evaluate the antioxidant and antimicrobial potentials of the cajazeira leaves, extractions at low pressure and high pressure were performed. The low pressure extractions (PLE) were carried out using Soxhlet (SOX) and tip ultrasound, using different solvents. Supercritical fluid extraction (SFE) was evaluated at temperature of 40?60°C and pressure of 150?300 bar besides extraction with cosolvent. Higher yields were obtained with the use of more polar solvents at LPE. The extracts obtained by SOX with ethanol and others polar solvents presented the best TPC values and antioxidant activity. The extracts at LPE with hexane and ethyl acetate and SFE presented better antimicrobial activity. Through liquid chromatography of high efficiency, it was possible to identify compounds with recognized biological activity, like ellagic acid, gallic acid and catechin.     

Identification of Phenylpyrazolone Dimers as a New Class of Anti-Trypanosoma cruzi Agents

Chagas disease is becoming a worldwide problem; it is currently estimated that over six million people are infected. The two drugs in current use, benznidazole and nifurtimox, require long treatment regimens, show limited efficacy in the chronic phase of infection, and are known to cause adverse effects. Phenotypic screening of an in-house library led to the identification of 2,2′-methylenebis(5-(4-bromophenyl)-4,4-dimethyl-2,4-dihydro-3H-pyrazol-3-one), a phenyldihydropyrazolone dimer, which shows an in vitro pIC₅₀ value of 5.4 against Trypanosoma cruzi. Initial optimization was done by varying substituents of the phenyl ring, after which attempts were made to replace the phenyl ring. Finally, the linker between the dimer units was varied, ultimately leading to 2,2′-methylenebis(5-(3-bromo-4-methoxyphenyl)-4,4-dimethyl-2,4-dihydro-3H-pyrazol-3-one (NPD-0228) as the most potent analogue. NPD-0228 has an in vitro pIC₅₀ value of 6.4 against intracellular amastigotes of T. cruzi and no apparent toxicity against the human MRC-5 cell line and murine cardiac cells.     

Proteome analysis of tissues by mass spectrometry

Tissues and biofluids are important sources of information used for the detection of diseases and decisions on patient therapies. There are several accepted methods for preservation of tissues, among which the most popular are fresh‐frozen and formalin‐fixed paraffin embedded methods. Depending on the preservation method and the amount of sample available, various specific protocols are available for tissue processing for subsequent proteomic analysis. Protocols are tailored to answer various biological questions, and as such vary in lysis and digestion conditions, as well as duration. The existence of diverse tissue‐sample protocols has led to confusion in how to choose the best protocol for a given tissue and made it difficult to compare results across sample types. Here, we summarize procedures used for tissue processing for subsequent bottom‐up proteomic analysis. Furthermore, we compare protocols for their variations in the composition of lysis buffers, digestion procedures, and purification steps. For example, reports have shown that lysis buffer composition plays an important role in the profile of extracted proteins: the most common are tris(hydroxymethyl)aminomethane, radioimmunoprecipitation assay, and ammonium bicarbonate buffers. Although, trypsin is the most commonly used enzyme for proteolysis, in some protocols it is supplemented with Lys‐C and/or chymotrypsin, which will often lead to an increase in proteome coverage. Data show that the selection of the lysis procedure might need to be tissue‐specific to produce distinct protocols for individual tissue types. Finally, selection of the procedures is also influenced by the amount of sample available, which range from biopsies or the size of a few dozen of mm² obtained with laser capture microdissection to much larger amounts that weight several milligrams.     

Computer Simulation of Water Vapor Adsorption on the Surface of a Crystal β-AgI Regular Shape Nanoparticle

Protection of Metals and Physical Chemistry of Surfaces - The Gibbs free energy and water vapor adsorption isotherms on the surface of a silver iodide nanoparticle at a temperature of 260 K have...     

Allele-Specific Inhibition of Histone Demethylases

Histone demethylases play a critical role in mammalian gene expression by removing methyl groups from lysine residues in degree- and site-specific manner. To specifically interrogate members and isoforms of this class of enzymes, we have developed demethylase variants with an expanded active site. The mutant enzymes are capable of performing lysine demethylation with wild-type proficiency, but are sensitive to inhibition by cofactor-competitive molecules embellished with a complementary steric “bump”. The selected inhibitors show more than 20-fold selectivity over the wild-type demethylase, thus overcoming issues typical to pharmacological and genetic approaches. The mutant–inhibitor pairs are shown to act on a physiologically relevant full-length substrate. By engineering a conserved amino acid to achieve member-specific perturbation, this study provides a general approach for studying histone demethylases in diverse cellular processes.     

Observations of Membrane Domain Reorganization in Mechanically Compressed Artificial Cells

Giant unilamellar vesicles (GUVs) are considered to be the gold standard for assembling artificial cells from the bottom up. In this study, we investigated the behavior of such biomimetic vesicles as they were subjected to mechanical compression. A microfluidic device is presented that comprises a trap to capture GUVs and a microstamp that is deflected downwards to mechanically compress the trapped vesicle. After characterization of the device, we show that single-phase GUVs can be controllably compressed to a high degree of deformation (D=0.40) depending on the pressure applied to the microstamp. A permeation assay was implemented to show that vesicle bursting is prevented by water efflux. Next, we mechanically compressed GUVs with co-existing liquid-ordered and liquid-disordered membrane phases. Upon compression, we observed that the normally stable lipid domains reorganized themselves across the surface and fused into larger domains. This phenomenon, observed here in a model membrane system, not only gives us insights into how the multicomponent membranes of artificial cells behave, but might also have interesting consequences for the role of lipid rafts in biological cells that are subjected to compressive forces in a natural environment.